Questions about Solder Pots
What is a solder pot used for?
A solder pot holds a bath of molten solder at a set temperature, so you can dip parts into it. It's used for tinning wire ends, dip soldering cable terminals and small parts, and removing through-hole parts near the edge of a circuit board. High-temperature pots can also strip the insulation off wire while they tin it. There's also a short article on keeping a pot in good shape.
What size solder pot do I need?
Pick a pot whose bath is bigger than the part you dip: a small pot for tinning wire ends, and a larger one for cable terminals and circuit boards. Our electric pots run from the American Beauty Mini Pot, with a bath 1 inch across, up to the Esico 80T, which is 6 by 12 inches. American Beauty and Esico are the same brand, and it's the one we prefer to sell.
Can I use lead-free solder in a solder pot?
Yes, as long as the pot runs hot enough for the alloy. Lead-free SAC305 melts at 423 to 430°F, and MacDermid Alpha, which makes it, recommends running it at 491 to 509°F in a wave solder pot. Every American Beauty and Esico pot we list goes above 600°F, and the Hakko FX-300 and FX-305 go above 800°F. Keep a separate pot for lead-free so the alloys don't mix. We also offer solder pot testing, and recommend it every quarter for high volume and every year for low volume.
Does a solder pot have temperature control?
Most of our solder pots have temperature control. The American Beauty D-300, D-900 and D-1400, the Esico PD24 and the Hakko FX-305 are digital, and they show both the temperature you set and the temperature in the pot. The Esico pots with a T in the model number and the American Beauty 300 and 600 have a thermostat, and the Hakko FX-300 has a dial. Whether a digital pot is worth it is covered here.
Can a solder pot melt lead?
Yes, if it runs above 621°F (327°C), where pure lead melts. For melting lead in bulk, such as for casting, the Johnson 200 gas pot holds 50 lb and is made for lead, babbitt, tin and zinc.